Move engine rebuild
Today in the post arrived 85% of the gaskets and seals needed to re assemble the engine for the Move. I got straight to it after work.
First up, change the rear crank oil seal for the new one.
Next fit new valve guide seals to the head.
Fit a new camshaft oil seal in the head.
Checked all the bottom end bolts to make sure they are at the correct settings and then plonk on the sump using a new sump gasket and sealant.
Alas the front crank oil seal was missing in the package, but I have more on order so when that arrives I can push that into place.
Last was clean up the rocker cover, fit a new rubber seal in the lid, and apply some new nut washers.
The head has also been put back together and is ready to bolt to the block when I am at that stage.