Front subframe tie rod bushes.
Right I have had a few suggestions and a few questions (looks in Spots direction) and to assists the answers I thought I would show what I have and how it all goes together.
First off is the old Tie rods loosely fitted to show how it goes together.
The new Tie bar is larger in diameter and uses 3/4″ UNC nuts not 5/8th UNC nuts, the reason for changing is that I can use the Jensen Healey front tie bar rubbers. I have a set of these already and they are much harder than the standard GT ones.
These all fit the tie bars perfectly and the new steel tubes are also zinc plates so no more seizing as they cannot rust. here is a test fitting with new zinc plates washers.
I will need to trim the little raised edge on the inside of the bush otherwise they appear to be a direct fit……